SparkFun XBee Explorer Dongle Microcontroller

SparkFun XBee Explorer Dongle MicrocontrollerDescription: This is the SparkFun XBee Explorer Dongle unit for the Digi XBee module line. With the XBee Explorer Dongle you can plug the unit directly into your USB port and have it act as a gateway between your computer and the XBee. No cables needed! This unit works with all XBee modules including the Series 1 and Series 2. 5, standard and Pro version. The on board voltage regulator is good up to 500mA. The highlight of this board is an FT231X USB

Virtually no sensor dead zone

You can use ouråÊiOS AppåÊoråÊAndroid AppåÊto get started sending data from your Arduino to your phone quickly and painlessly

There's a single LED backlight for the entire display

3v 250mA regulator with a protection diode and USB fuse so that the microcontroller voltage is consistent and can power common 3

Cured rubber is very soft

or raw data format

Single LED backlight included can be dimmed easily with a resistor or PWM and uses much less power than LCD with EL (electroluminescent) backlights

20sec/60å¡ at no load

two cores so you don't have to yield to the WiFi manager

Built in over-the-air bootloading capability so we can keep you updated with the hottest new firmware

Lipoly battery and USB cable not included

In comparison