Egt to Can module Ecumaster dash

Egt to Can module Ecumaster dashThe EGT to CAN module collects input signals from 8 EGT probes (K Type thermocouples), converts the probe voltage into a numerical temperature figure and sends the appropriate data via a CAN bus. The module is fully configurable using USB connection and Microsoft Windows based client software. High quality EGT sensors are available on request. Using ECUMASTER EMU engine management it is possible to trim each cylinder fuel dose based on EGT

Call us for custom wiring

The main improvements are as follows:

2 inch display

The use of WHP wideband knock sensors allows for greater sensitivity to knock and greater control of the engine

Boost scramble 5 pos /Traction control 5 pos

At home in any engine from Fast Road to Motorsport use

75mm^2 - 1x PGND - A11

Max Air Flow rate: ~65 lb/min

based on auto-update best reference lap is a feature of the qualification mode which can be activated by selecting the qualification page

- Pre-crimped cables

Garrett Conversions

The components used allows continued operation in a very wide temperature range (AECQ-100 GRADE 2 (-40 to +105˚C)